F8E2 is KitchenAid's fill valve electric error: look at the inlet valve connection, then cycle power.
Model compatibility: KitchenAid reuses codes across series and model years, so F8E2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Fill valve electric error; inspect the inlet valve connection for leaks under the drip tray, power cycle, and book service if it recurs.
Two items make up KitchenAid’s owner-help answer to the “Fill Valve Electric Error,” F8E2, and a service appointment waits until both are done.
At a glance
| Code | F8E2 |
|---|---|
| What it means | An electrical error in the fill valve, handled by checking the inlet valve connection for leaks and cycling the power. |
| What you can check | Take out the drip tray carefully, since the float switch wire stays attached, and look over the inlet valve connection for any sign of a leak. Then reset: unplug or switch the breaker off for 30 seconds. |
| When to call a technician | Should the code return after the leak check and the 30-second reset, schedule service. Tell the technician what you saw at the inlet connection and whether the reset was tried. |
Item one: connection at the inlet valve
Take out the drip tray, the plastic pan beneath the unit, and look over the inlet valve connection for any sign of a leak. For releasing the tray, a related article says to squeeze each side snap in toward the center, then draw the tray out toward yourself. It also cautions that the float switch wire is still fixed to it. Extra distance or force when pulling could damage that wire. Slow movement helps, and turning the power off beforehand is a sensible general precaution.
Item two: the 30-second reset
Plug-in units: unplug, wait, plug in again. Hard-wired units: breaker off at the home panel, wait, breaker on. Each wait is 30 seconds. When the code comes back after that, KitchenAid wants service scheduled.
How F8E2 differs from other fill valve entries
Several codes mention the fill valve, which causes confusion. F8E2 pairs an electric error with the inlet leak look. F6E2 gives an electrical list: loose connection, open solenoid, open fuse or drive circuit. F8E5 covers a valve that sticks open and has shut-off steps of its own.
Open questions
KitchenAid does not explain the link between a leak look and an electric error, and no electrical causes are listed for this code.
Water in the tray?
Read F8E4 as well; it concerns the same tray and the inlet connection.
KitchenAid fill valve repair for metro customers
For the Miami, New York, Houston, Los Angeles and San Diego metro areas, (844) 919-2035 reaches us about a KitchenAid dishwasher showing F8E2. Say what you saw at the inlet connection and whether the reset was tried. The dishwasher repair page is also available.
Source: KitchenAid Product Help, Dishwasher Error Code or Flashing Lights
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.