KitchenAid Dishwasher F1E1 Error Code
F1E1 is a KitchenAid dishwasher diagnostic usually grouped with main control / stuck relay. This page keeps DIY limits clear for metro homeowners.
Owner-facing decode for KitchenAid controls — cross-check the tech sheet before any repair decision.
Decode F1E1 for KitchenAid dishwasher owners: Main control / stuck relay.
Model compatibility: KitchenAid reuses codes across series and model years, so F1E1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
The control has detected a main-control or stuck-relay type fault. Power-cycle once; if F1E1 returns, the control or a connected load needs professional diagnosis. Exact KitchenAid fault text shifts by model and control generation — always confirm against your use & care guide or tech sheet.
Symptoms you may notice
- The dishwasher shows F1E1 and controls act erratically
- F1E1 appears at power-on
- Programs won’t start reliably with F1E1
Possible causes
- A control-board fault
- A power or wiring irregularity
- A firmware or electronics glitch
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Confirm stable power at the outlet
- Perform a manufacturer-approved restart once
- Record the full model number
- Share freezer vs fridge temperatures, or wash/heat symptoms, when you book service
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
When to call a technician
Call Artisan Repair if F1E1 comes back, the appliance will not run safely, or you smell burning / see standing water near electrics.
Likely related component
control board
Frequently asked questions
The control has detected a main-control or stuck-relay type fault. Power-cycle once; if F1E1 returns, the control or a connected load needs professional diagnosis.
Many KitchenAid codes drop after airflow, drain, or door issues are corrected. Returning F1E1 needs a tech.
Treat shared wording as a clue only — verify F1E1 before buying parts.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.