KitchenAid KDTE554 Built-in Dishwasher

A 24-inch cutout, a stainless steel tub and two nylon-coated racks define the KitchenAid KDTE554, a built-in dishwasher. Its AquaSense system recycles wash water during a cycle, and a soil sensor adjusts the wash to how dirty the load is. A delayed-start setting lets the owner schedule a later run. The listed electrical rating is 120 V, so the circuit should be matched before any service call. Across the metro areas we cover, a stalled cycle or a leak code is the usual reason for a call. For the booking form, give the full number from the rating label, the cycle or light that fails and any leak code shown.

At a glance

Specifications

What sets the KDTE554 apart

The AquaSense recycling loop separates this model from dishwashers that drain fresh water on every cycle. Its soil sensor changes the wash for lightly or heavily soiled loads, and the nylon coating on the racks cushions dishes as they are loaded. Day to day, the delayed-start setting fits a schedule, and the stainless tub is the standard build.

Service notes for the KDTE554

Dishes that come out dirty or wet lead a technician to the spray arms, the soil sensor and the filter, since a blocked filter forces the recycling loop to carry debris. The owner can clean the filter and clear the spray arm openings before the visit. A door latch or panel fault usually traces to a worn latch or a loose connector behind the door panel. Leak codes start at the inlet valve, the drain hose or the tub seal, and a puddle along the door edge helps the owner narrow it down. A cycle that stops early often means the door did not close fully. Disconnect power before opening the lower panel.

The model number is printed on the rating label, usually on the edge of the door or the side of the tub, visible when the door is open; match it letter for letter before booking, because a single letter can change parts.