F4E7 names the microwave meat probe, its receptacle or wiring. Reseat the right probe, reset power, then call if it returns.
Model compatibility: KitchenAid reuses codes across series and model years, so F4E7 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Possible problem with the Microwave Meat Probe, the Meat Probe Receptacle or its wiring.
Did you have a probe in when F4E7 came up? Start with it. KitchenAid’s advice is to verify the microwave meat probe is inserted all the way in the microwave meat probe receptacle.
At a glance
| Code | F4E7 |
|---|---|
| What it means | Possible problem with the Microwave Meat Probe, the Meat Probe Receptacle or its wiring. |
| What you can check | Pull the probe out and insert it fully into the microwave's own receptacle, never the oven's probe. Then turn the oven breaker off for sixty seconds, on again, watch a minute for F4E7, and run the oven. |
| When to call a technician | If a correct, fully seated probe still gives F4E7 after the reset, book service. A damaged probe cable or a faulty receptacle is a question for a technician. |
Three candidates
| Part | Can an owner act? |
|---|---|
| Microwave meat probe | Sometimes, by reseating it |
| Meat probe receptacle | No |
| Wiring | No |
If a probe cable appears damaged, KitchenAid’s article says nothing, so replacement is a question for a technician.
KitchenAid’s warning
Never plug the oven’s meat probe into the microwave. The resistance values of the two are different, per KitchenAid, so they cannot be swapped. Rule out the mix-up if your probe came from the other oven.
Procedure
Pull the probe out and insert it fully into the microwave receptacle, making sure it is the microwave’s own. Next, turn the oven breaker off for sixty seconds and then on. Give it a minute under observation for F4E7. Last, run the oven.
Can I borrow the other oven’s probe?
No. The resistance values differ, so KitchenAid rules the oven probe out for microwave use.
Time to stop
A seated, correct probe and a code that returns after the reset means it is time to book service.
Codes about probes
- F3E4: a code for the other oven’s probe, and the roll-out rack power attachment
- 3D31 / 3D32 / 3D41: meat probe not secure in the receptacle
Probe fault service in several metro areas
We work in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Phone (844) 919-2035, give F4E7, and tell us which probe was plugged in. See the oven repair page for what helps us prepare.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.