KitchenAid KBFC42F Built-in French-Door Refrigerator
Built-in French-door fridge where a leak near the filter, a frosted freezer or a silent ice maker prompts the call.
Model overview
A 42-inch built-in French-door refrigerator with a bottom freezer and an automatic ice maker, the KitchenAid KBFC42F suits a cabinet run that needs a flush face. In its FTS configuration it provides 22.6 cu. ft. of total capacity behind stainless-steel doors. Touch-sensor controls adjust the refrigerator settings, and a pushbutton Fast Flow water filter feeds the ice maker, so a leak or an ice stoppage can start on the same line. The freezer has one full-width basket. Customers across the metro areas we cover often report a wet floor near the filter or a silent ice maker. Pass along the complete number from the rating label, the compartment that is wet or frosted and the ice or water symptom when you book.
At a glance
| Model | KBFC42F |
|---|---|
| Appliance | 42-inch built-in French-door refrigerator |
| Common symptoms | water leaking inside or under the unit; freezer frosting up or not holding temperature; ice maker or dispenser not working; compressor or fan running loud or nonstop |
| What you can check | Note how long the temperature has been off and whether the freezer side is affected too. |
| When to call a technician | If the symptom comes back after the simple checks, or you see a code, leaking water or a burning smell, book a visit. |
Specifications
| Capacity | The FTS configuration has 22.6 cu. ft. total capacity. |
|---|---|
| Power | Requires a grounded 115 V, 60 Hz AC supply with a 15- or 20-amp fuse. |
| Features | An automatic ice maker is factory installed. Adjustable SpillClean glass shelves contain spills. A PUR pushbutton Fast Flow water filter is provided. The freezer has one full-width basket. |
| Controls | Touch-sensor controls adjust refrigerator settings. |
| Finish | The FTS doors have a stainless-steel finish. |
What sets the KBFC42F apart
The stainless doors and a single full-width freezer basket are what set this unit apart in daily use. The filter and the ice maker share one water path, so a filter change can affect ice output as well as the tap. Touch controls keep the fridge settings on the door face. The model is discontinued, so matching the filter and fill valve to the rating label matters before anything is ordered.
Service notes for the KBFC42F
A leak inside or under the cabinet usually starts at the filter housing, the ice maker fill valve or the defrost drain, and a technician checks those points first. Freezer frost tends to mean a door seal, a defrost heater or a fan that is not moving air, so the owner can check that the full-width basket does not press the door out of line. An ice maker that stops while the fridge still cools points to the water valve or the filter cartridge rather than the sealed system. Before the visit, the owner can note whether the filter was changed recently and what the touch panel displays. Disconnect power before pulling the cabinet forward.
The model number is printed on the rating label, usually on a side wall or the ceiling inside the fresh-food section, or behind the base grille; match it letter for letter before booking, because a single letter can change parts.
Common issues for this model
- Water leaking inside or under the unit
- Freezer frosting up or not holding temperature
- Ice maker or dispenser not working
- Compressor or fan running loud or nonstop
Related error codes
KitchenAid Undercounter Codes E1 and E2: Power Cycle Only
KitchenAid undercounter units can show E1 or E2; its help gives a power cycle and does not name a cause.
KitchenAid Refrigerator Flashing F Code: What It Means
The flashing F on KitchenAid refrigerators is a general fault flag. Power-cycle the unit, verify cooling is on, and arrange service if the F persists.
KitchenAid Refrigerator F3E1 to F8EC Error Codes
Thirteen refrigerator codes share a single KitchenAid entry with no cause stated. Reset the power, confirm cooling, then arrange service if needed.
KitchenAid Refrigerator / Beverage Center Code CL / LO: Temperature Too Low
A KitchenAid beverage center showing CL (or LO) reports that its internal temperature is too low.
Recommended repair service
Refrigerator Repair
Losing cooling, building frost, or pooling water? We diagnose KitchenAid refrigerator faults and restore reliable, efficient cooling.
Troubleshooting resources
Note how long the temperature has been off and whether the freezer side is affected too.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Frequently asked questions
It needs a grounded 115 V, 60 Hz AC supply with a 15- or 20-amp fuse.
The FTS configuration has 22.6 cu. ft. of total capacity.
Check the rating label on a side wall or the ceiling inside the fresh-food section, or behind the base grille. Copy every letter and digit, including the ones at the end.
Yes. We book in-home visits for this model in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Add the model number and the symptom to the booking form.
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.