KitchenAid Refrigerator E1 Error Code
Compressor fault (E1) — high or low compressor amperage detected by the control.
E1 from KitchenAid under-counter service manual Error Code Detection chart.
Compressor fault (E1) — high or low compressor amperage detected by the control.
Model compatibility: KitchenAid reuses codes across series and model years, so E1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Compressor fault (E1) — high or low compressor amperage detected by the control.
Symptoms you may notice
- E1 displayed
- No cooling
- Compressor may not start or runs abnormally
Possible causes
- Disconnected compressor wires
- Failed compressor or overload
- Failed control board
- Failed PTC starter
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Disconnect power at the breaker for five minutes, then restore to clear stored alarms. Press alarm/controls per your manual if applicable.
- Do not attempt compressor repair — sealed system and line voltage
- Book independent KitchenAid service
Important safety warning. Never open the sealed refrigerant system. Condenser fan and compressor work involves high voltage.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
When to call a technician
If E1 persists after the safe checks above, book Artisan Repair for independent KitchenAid diagnosis with your model and serial numbers. Not an official KitchenAid service center.
Likely related component
Compressor circuit
Frequently asked questions
Share the KitchenAid model and symptom (mixer hum, fridge warm-up, range ignition, and so on). We confirm a metro appointment window, diagnose on site, then give a written estimate you approve before any parts go in.
Yes. After diagnosis you get an upfront estimate. No KitchenAid parts are ordered or installed until you approve — including sealed-system or gas work when those apply.
Yes. We use original manufacturer parts matched to your model. We confirm the part and cost with you before anything is ordered or installed.
No. Sealed refrigeration, gas valves, and live control boards are technician-only. Safe homeowner checks stop at filters, seals, approved descaling, and what your model manual lists as user-serviceable.
We serve the Miami, New York, Houston, Los Angeles and San Diego metro areas for KitchenAid appliance repair. Contact us with your ZIP code to confirm coverage.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.