KitchenAid Dishwasher F8E5 Error Code
If your KitchenAid dishwasher shows F8E5, start with the safe checks here — the code often tracks leak / float before any parts talk.
Owner-facing decode for KitchenAid controls — cross-check the tech sheet before any repair decision.
KitchenAid dishwasher code F8E5: Leak / float — verify on your tech sheet.
Model compatibility: KitchenAid reuses codes across series and model years, so F8E5 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Leak or float-switch related fault. Control generations differ across KitchenAid lines — photograph the full code and rating label before ordering parts.
Symptoms you may notice
- The dishwasher halts and displays F8E5
- You notice moisture or water near the dishwasher
- The dishwasher won’t resume its cycle normally
Possible causes
- A minor internal leak reaching the base
- A loose or aging hose connection
- Residual water triggering the protection system
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Switch the appliance off and, if safe, disconnect power
- Check for visible water under or behind the appliance
- Confirm hoses and connections are not visibly dripping
- Keep notes on any recent power outages, filter changes, or installs before the visit
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
When to call a technician
If F8E5 persists after the safe checks above, book Artisan Repair for independent KitchenAid diagnosis with your model and serial numbers. Not an official KitchenAid service center.
Likely related component
anti-leak / base sensor
Frequently asked questions
Leak or float-switch related fault.
Often yes after fixing the underlying condition and power-cycling once. If F8E5 returns immediately, stop DIY and book independent service.
Control generations differ across KitchenAid lines — photograph the full code and rating label before ordering parts.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.