KitchenAid KDTM404KPS Dishwasher
Built-in dishwasher — model reference for identification and compatibility.
Model overview
KitchenAid built-in dishwasher. Common drainage, cleaning and control issues are listed below with related services.
At a glance
| Model | KDTM404KPS |
|---|---|
| Appliance | built-in dishwasher |
| Common symptoms | drainage problems, poor cleaning, control issues |
| What you can check | No owner steps are given for this dishwasher, so write down what the dishes look like after a cycle, whether water stays in the tub, and any code shown on the panel. |
| When to call a technician | Book a technician when drainage or control trouble comes back, or when the cause is not obvious. Related service options cover the drain and control parts that need a trained hand. |
Common issues for this model
- Not draining / standing water
- Poor cleaning results
- Cycle will not start
Related error codes
KitchenAid Dishwasher Code F1E1: Control Module
F1E1 is the control module code. The manufacturer's remedy is a 30-second power cycle, with service if the code comes back.
KitchenAid Dishwasher F2E1 Code: Stuck Key or Console Error
F2E1 on a KitchenAid dishwasher: stuck key or console error per KitchenAid. A 30-second power cycle is the published step.
KitchenAid Dishwasher F3E1 Code: Thermistor Circuit Open
F3E1: KitchenAid's service documents call it an open thermistor/OWI sensor circuit. Three causes are listed and no owner fix is given.
KitchenAid Dishwasher F9E1 Code: Long Drain
F9E1 is a long drain. KitchenAid lists four checks; the service tables describe a diverter that cannot find position.
Recommended repair service
Dishwasher Repair
Dishwasher not draining, not cleaning, or showing an error code? We find the cause and get your KitchenAid dishwasher back to spotless cycles.
Troubleshooting resources
Confirm the exact model from the door label before booking.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Frequently asked questions
Share the KitchenAid model and symptom (mixer hum, fridge warm-up, range ignition, and so on). We confirm a metro appointment window, diagnose on site, then give a written estimate you approve before any parts go in.
Yes. After diagnosis you get an upfront estimate. No KitchenAid parts are ordered or installed until you approve — including sealed-system or gas work when those apply.
Yes. We use original manufacturer parts matched to your model. We confirm the part and cost with you before anything is ordered or installed.
No. Sealed refrigeration, gas valves, and live control boards are technician-only. Safe homeowner checks stop at filters, seals, approved descaling, and what your model manual lists as user-serviceable.
We serve the Miami, New York, Houston, Los Angeles and San Diego metro areas for KitchenAid appliance repair. Contact us with your ZIP code to confirm coverage.
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.