KitchenAid KBSN608ESS Built-in Side-by-Side Refrigerator
48-inch side-by-side where a compartment runs warm, crispers stick or the automatic ice maker goes quiet.
Model overview
The KitchenAid KBSN608ESS is a 48-inch built-in side-by-side refrigerator with a nominal storage capacity of 30.0 cu. ft. ExtendFresh Plus manages the temperature of each compartment, and the Produce Preserver sits in the crisper area. The crisper drawers run on SatinGlide slides, and the PrintShield exterior is meant to resist fingerprints. An automatic ice maker is provided, so a dead ice maker can point to the water line or the fill valve. Electronic controls set the temperatures, and LED lights illuminate the interior. Owners in the metro areas we cover should measure the opening against the listed size first. For the booking form, give the full model number from the rating label, the compartment with the trouble and any ice or water symptom.
At a glance
| Model | KBSN608ESS |
|---|---|
| Appliance | 48-inch built-in side-by-side refrigerator |
| Common symptoms | water leaking inside or under the unit; compressor or fan running loud or nonstop; ice maker or dispenser not working; fresh-food section not cooling to the set temperature |
| What you can check | Note how long the temperature has been off and whether the freezer side is affected too. |
| When to call a technician | If the symptom comes back after the simple checks, or you see a code, leaking water or a burning smell, book a visit. |
Specifications
| Capacity | Nominal storage capacity is 30.0 cu. ft. |
|---|---|
| Features | ExtendFresh Plus manages compartment temperatures. A Produce Preserver is provided. The crisper drawers use SatinGlide slides. An automatic ice maker is provided. Interior lighting uses LEDs. |
| Controls | Temperature settings use electronic controls. |
| Finish | The exterior has a PrintShield finish. |
What sets the KBSN608ESS apart
Large built-in side-by-sides look similar, so the choices that matter are the compartment controls and the finish. This one uses ExtendFresh Plus to manage each compartment, a Produce Preserver and crispers on SatinGlide slides. The PrintShield exterior is a practical difference in a kitchen where the front gets touched often. Day to day, the owner can keep the produce side and the main side at separate settings, which changes how the crispers are loaded.
Service notes for the KBSN608ESS
When one compartment drifts from its setting, a technician checks the ExtendFresh Plus sensors and the damper that feeds each section, because a sensor that reads wrong can push cold air toward the wrong side. Crisper drawers that stick are usually a runner or seal problem rather than a cooling fault. Ice maker or dispenser issues start at the water line, the fill valve or the filter, and the owner can safely confirm the water supply is open and the ice maker switch is on. Compressor or fan noise should be noted with the time and room temperature. Disconnect power before pulling the cabinet forward for any inspection.
The model number is printed on the rating label, usually on a side wall or the ceiling inside the fresh-food section, or behind the base grille; match it letter for letter before booking, because a single letter can change parts.
Common issues for this model
- Water leaking inside or under the unit
- Compressor or fan running loud or nonstop
- Ice maker or dispenser not working
- Fresh-food section not cooling to the set temperature
Related error codes
KitchenAid Refrigerator Flashing F Code: What It Means
The flashing F on KitchenAid refrigerators is a general fault flag. Power-cycle the unit, verify cooling is on, and arrange service if the F persists.
KitchenAid Refrigerator H2O Light: Filter Status and Reset
H2O is a filter reminder, not a breakdown. Put in a new water filter, then hold the reset buttons to clear the light.
KitchenAid Refrigerator F3E1 to F8EC Error Codes
Thirteen refrigerator codes share a single KitchenAid entry with no cause stated. Reset the power, confirm cooling, then arrange service if needed.
KitchenAid Refrigerator / Beverage Center Code CL / LO: Temperature Too Low
A KitchenAid beverage center showing CL (or LO) reports that its internal temperature is too low.
Recommended repair service
Refrigerator Repair
Losing cooling, building frost, or pooling water? We diagnose KitchenAid refrigerator faults and restore reliable, efficient cooling.
Troubleshooting resources
Note how long the temperature has been off and whether the freezer side is affected too.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Frequently asked questions
It is a 48-inch built-in side-by-side with a nominal 30.0 cu. ft. of storage.
Yes, an automatic ice maker is provided, so check the water supply first if ice stops.
Check the rating label on a side wall or the ceiling inside the fresh-food section, or behind the base grille. Copy every letter and digit, including the ones at the end.
Yes. We book in-home visits for this model in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Add the model number and the symptom to the booking form.
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.