KitchenAid Washing Machine 4D42 Error Code
Artisan Repair techs treat 4D42 on a KitchenAid washing machine as a laundry diagnostic code starting point, then verify against your model sheet.
KitchenAid homeowner guide language only — not a factory service procedure.
4D42 · KitchenAid washing machine · Laundry diagnostic code (model-dependent).
Model compatibility: KitchenAid reuses codes across series and model years, so 4D42 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
KitchenAid laundry electronics may show 4D42 when laundry diagnostic code is out of range. Redistribute the load and clear the drain path before a second reset. If your manual lists a different description for this code, trust the manual over any general summary.
Symptoms you may notice
- The washing machine displays 4D42 during operation
- 4D42 appears without an obvious cause
- The washing machine behaves inconsistently with 4D42 shown
Possible causes
- A sensor reading out of range
- A wiring or connection issue
- A control interpreting the reading as a fault
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Confirm the appliance has stable power
- Check for visible blockages or obstructions
- Record the full model number
- Write down when 4D42 appeared and which cycle or mode was running
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
When to call a technician
If 4D42 persists after the safe checks above, book Artisan Repair for independent KitchenAid diagnosis with your model and serial numbers. Not an official KitchenAid service center.
Likely related component
a sensor
Frequently asked questions
KitchenAid laundry electronics may show 4D42 when laundry diagnostic code is out of range. Redistribute the load and clear the drain path before a second reset.
Clearing the display is not the same as fixing the cause. If 4D42 comes back, schedule diagnosis.
Not reliably. Two similar KitchenAid displays can map 4D42 differently by series.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.