KitchenAid Oven F1-H Error Code
If your KitchenAid oven shows F1-H, start with the safe checks here — the code often tracks oven control code before any parts talk.
KitchenAid homeowner guide language only — not a factory service procedure.
F1-H — Oven control code on a KitchenAid oven (confirm for your model).
Model compatibility: KitchenAid reuses codes across series and model years, so F1-H may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
F1-H typically maps to oven control code on KitchenAid wall ovens and ranges — confirm your control generation before ordering parts. Control generations differ across KitchenAid lines — photograph the full code and rating label before ordering parts.
Symptoms you may notice
- The oven displays F1-H during operation
- F1-H appears without an obvious cause
- The oven behaves inconsistently with F1-H shown
Possible causes
- A sensor reading out of range
- A wiring or connection issue
- A control interpreting the reading as a fault
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Confirm the appliance has stable power
- Check for visible blockages or obstructions
- Record the full model number
- Write down when F1-H appeared and which cycle or mode was running
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
- Do not adjust, disconnect or repair any gas connection or valve
When to call a technician
If F1-H persists after the safe checks above, book Artisan Repair for independent KitchenAid diagnosis with your model and serial numbers. Not an official KitchenAid service center.
Likely related component
a sensor
Frequently asked questions
F1-H typically maps to oven control code on KitchenAid wall ovens and ranges — confirm your control generation before ordering parts.
Safe homeowner resets may clear F1-H temporarily; sealed, gas, and live-board work stay with a technician.
Platform families overlap, but Artisan Repair still confirms F1-H against your serial family.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.