F2 reports a cooking area that has not cooled enough. It clears after cooling, and the breaker reset is a fallback.
Model compatibility: KitchenAid reuses codes across series and model years, so F2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
KitchenAid reports that the surface cooking area is still too hot; F2 clears after cooling.
F2 in short
| Question | Answer from KitchenAid |
|---|---|
| What is reported? | The surface cooking area is still too hot |
| Is a part broken? | No, it is a heat condition |
| When does it go? | When the area has cooled |
Of all the heat messages on these cooktops, F2 demands the least. It describes no damage; the burner area simply has not cooled yet.
At a glance
| Code | F2 |
|---|---|
| What it means | KitchenAid reports that the surface cooking area is still too hot; F2 clears after cooling. |
| What you can check | Move the cookware aside, switch that cooking area off and leave it to cool. Only if F2 survives a full cool-down, turn the breaker off for a minute, back on, and watch for a minute. |
| When to call a technician | If F2 still shows after the area has cooled and the breaker reset, call for service. Have the code and the length of the cool-down ready. |
The order to follow
- Set the cookware aside, away from the burner area.
- Switch that area off and leave it to cool.
- Try again later. F2 appearing a second time means the heat is still too high, and the cool-down starts over.
Breaker reset as a last resort
KitchenAid’s article brings in the power reset only for a code that survives a full cool-down. Turn the supply off at the breaker for a minute, turn it on, let the cooktop run under observation for another minute, and confirm normal behavior.
Common question
Does F2 mean the cooktop failed?
It does not. The article presents a state that ends once things cool off, and pressing the control again does nothing to speed that up.
Similar heat messages
- C81 / C83: the cooktop overheated and shut off automatically; wait five minutes and check the airflow.
- F8: a zone ran too long and the automatic shutoff ended it.
- H: the hot-surface light.
Cooktop service across our metro areas
For a KitchenAid cooktop in the Miami, New York, Houston, Los Angeles or San Diego metro areas that still shows F2 after cooling and a breaker reset, call (844) 919-2035. Have the code and the length of the cool-down ready.
Source: KitchenAid Product Help, Electric Cooktop: Error Code or Indicator Light
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.