KitchenAid Refrigerator LA Error Code
Low temperature alarm (LA) — compartment temperature fell below the low alarm preset for an extended period.
LA definition from KitchenAid under-counter controller troubleshooting guide.
Low temperature alarm (LA) — compartment temperature fell below the low alarm preset for an extended period.
Model compatibility: KitchenAid reuses codes across series and model years, so LA may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Low temperature alarm (LA) — compartment temperature fell below the low alarm preset for an extended period.
Symptoms you may notice
- LA flashing
- Excessively cold zone
- Alarm until reset
Possible causes
- Set point very low with heavy load
- Sensor fault
- Control overshoot
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Verify set temperature appropriate for contents
- Allow stabilization after changes
- Reset alarm per manual
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
When to call a technician
If LA persists after the safe checks above, book Artisan Repair for independent KitchenAid diagnosis with your model and serial numbers. Not an official KitchenAid service center.
Likely related component
Low-temperature alarm
Frequently asked questions
Share the KitchenAid model and symptom (mixer hum, fridge warm-up, range ignition, and so on). We confirm a metro appointment window, diagnose on site, then give a written estimate you approve before any parts go in.
Yes. After diagnosis you get an upfront estimate. No KitchenAid parts are ordered or installed until you approve — including sealed-system or gas work when those apply.
Yes. We use original manufacturer parts matched to your model. We confirm the part and cost with you before anything is ordered or installed.
No. Sealed refrigeration, gas valves, and live control boards are technician-only. Safe homeowner checks stop at filters, seals, approved descaling, and what your model manual lists as user-serviceable.
We serve the Miami, New York, Houston, Los Angeles and San Diego metro areas for KitchenAid appliance repair. Contact us with your ZIP code to confirm coverage.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.