KitchenAid Oven FCRR Error Code
FCRR is a KitchenAid oven diagnostic usually grouped with control / clock. This page keeps DIY limits clear for metro homeowners.
Reviewed for clarity on KitchenAid appliances; always match the code to your specific model.
FCRR on KitchenAid oven appliances often means Control / clock.
Model compatibility: KitchenAid reuses codes across series and model years, so FCRR may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Oven control related fault code. Artisan Repair uses the code as a starting clue; final diagnosis still follows your appliance’s documentation.
Symptoms you may notice
- The oven shows FCRR and controls act erratically
- FCRR appears at power-on
- Programs won’t start reliably with FCRR
Possible causes
- A control-board fault
- A power or wiring irregularity
- A firmware or electronics glitch
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Confirm stable power at the outlet
- Perform a manufacturer-approved restart once
- Record the full model number
- Write down when FCRR appeared and which cycle or mode was running
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
- Do not adjust, disconnect or repair any gas connection or valve
When to call a technician
If FCRR persists after the safe checks above, book Artisan Repair for independent KitchenAid diagnosis with your model and serial numbers. Not an official KitchenAid service center.
Likely related component
control board
Frequently asked questions
Oven control related fault code.
Many KitchenAid codes drop after airflow, drain, or door issues are corrected. Returning FCRR needs a tech.
No — KitchenAid control generations differ. Match FCRR to your exact documentation.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.