KitchenAid KUDE20F Built-in Dishwasher
Built-in dishwasher with concealed controls and 14-setting capacity; early stops, wet dishes and leak codes are typical calls.
Model overview
The KitchenAid KUDE20F is a built-in dishwasher that holds up to 14 place settings across five wash cycles. ProWash adjusts the wash in real time, and a high-temperature wash option is available for heavier loads. The control panel is concealed, and the upper rack has height adjusters for taller items. Heated drying is included. It needs a fused 120 V, 60 Hz AC supply on a 15- or 20-amp circuit. Across the metro areas we cover, a cycle that stops early and dishes that come out wet are typical calls. When you book, give the symptom, the KUDE20F number from the rating label, and any error code that appears on the panel.
At a glance
| Model | KUDE20F |
|---|---|
| Appliance | 24-inch built-in dishwasher |
| Common symptoms | cycle stops early or will not start; dishes not getting clean or dry; leak or leak-protection code; door latch or control panel problems |
| What you can check | Note the cycle used, whether water is left in the tub, and any code or flashing light. |
| When to call a technician | If the symptom comes back after the simple checks, or you see a code, leaking water or a burning smell, book a visit. |
Specifications
| Capacity | Holds up to 14 place settings. |
|---|---|
| Power | Requires a fused 120 V, 60 Hz AC, 15- or 20-amp supply. |
| Features | The upper rack has height adjusters. Provides five wash cycles. ProWash adjusts the wash in real time. Includes a high-temperature wash option. Includes heated drying. |
| Controls | The control panel is concealed. |
What sets the KUDE20F apart
A concealed control panel is what distinguishes this dishwasher from one with a visible console, since the controls stay out of sight. ProWash responds to the load during the wash, and the high-temperature option adds heat for heavier loads. The upper rack adjusters let the owner change rack height to fit taller items.
Service notes for the KUDE20F
A cycle that stops early or will not start points the technician to the door latch and the concealed panel, since the start signal depends on both. Dishes that come out dirty or wet are checked at the spray arms, the filter, and the heated drying element. A leak code leads to the hose, the float and the base, and the owner should keep the unit off until the base is dry. Door latch trouble is checked at the latch mechanism and its switch. The owner can safely clear the filter, confirm the upper rack is seated, and make sure the door latches fully before calling.
The model number is printed on the rating label, usually on the edge of the door or the side of the tub, visible when the door is open; match it letter for letter before booking, because a single letter can change parts.
Common issues for this model
- Cycle stops early or will not start
- Dishes not getting clean or dry
- Leak or leak-protection code
- Door latch or control panel problems
Related error codes
KitchenAid Dishwasher F3E3 Code: Thermistor/OWI Calibration
F3E3 is a failed thermistor/OWI calibration; the listed causes are an OWI failure or a drain hose check valve letting dirty water back in.
KitchenAid Dishwasher F6E7 Code: Flowmeter Fault
F6E7 means the flowmeter on the inlet side is disconnected or damaged. Water softener and flowmeter models only.
KitchenAid Dishwasher F4E3 Code: Heating Error
F4E3 is a heating error in KitchenAid's owner help. A 30-second power cycle is the step, with service if the code returns.
KitchenAid Dishwasher F2E1 Code: Stuck Key or Console Error
F2E1 on a KitchenAid dishwasher: stuck key or console error per KitchenAid. A 30-second power cycle is the published step.
Recommended repair service
Dishwasher Repair
Dishwasher not draining, not cleaning, or showing an error code? We find the cause and get your KitchenAid dishwasher back to spotless cycles.
Troubleshooting resources
Note the cycle used, whether water is left in the tub, and any code or flashing light.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Frequently asked questions
It holds up to 14 place settings.
Yes. Heated drying is included with the five wash cycles.
Check the rating label on the edge of the door or the side of the tub, visible when the door is open. Copy every letter and digit, including the ones at the end.
Yes. We book in-home visits for this model in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Add the model number and the symptom to the booking form.
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.