KitchenAid KRFC302ESS French Door Refrigerator
36" french door refrigerator — model notes, common issues and related KitchenAid refrigerator service.
Model overview
Here are a few checks that are safe on a 36-inch KitchenAid French door refrigerator, KRFC302ESS, before you call. Confirm the cabinet is level and not pressed tight against a wall, since a snug gap can make the compressor work harder. Look at the door gaskets for food residue or cracks that let warm air in. If frost has built up on the freezer back wall, switch the unit off at the wall and let it thaw on a towel rather than chipping at the ice. Check the water line and the drip tray for moisture. Never reach into the back panel while the unit is plugged in. In the booking form, name the symptom, type KRFC302ESS and note any beep pattern or display message.
At a glance
| Model | KRFC302ESS |
|---|---|
| Appliance | 36-inch French door refrigerator |
| Common symptoms | compressor working hard, warm air leaking in, frost on freezer back wall, moisture near water line |
| What you can check | Make sure the cabinet is level and not pressed tight to a wall. Check the door gaskets for residue or cracks, and look at the water line and drip tray for moisture. |
| When to call a technician | If frost has built up, switch the unit off at the wall and thaw it on a towel instead of chipping. Never reach into the back panel while it is plugged in; call a technician if problems continue. |
KRFC302ESS is a KitchenAid 36″ french door refrigerator. The model number is printed on the rating label, usually on a side wall or the ceiling inside the fresh-food section, or behind the base grille; match it letter for letter before booking, because a single letter can change parts.
Specifications
| Dimensions | Overall height is 72 inches. |
|---|---|
| Capacity | Nominal total capacity is 21.9 cubic feet. |
| Power | Supply requirements are 115 volts, 60 hertz and a 15- or 20-ampere circuit. |
| Installation | Water supply pressure must be 35–120 psi. |
| Features | A removable metal rack stores wine bottles. Filtered water is dispensed inside the refrigerator. The pull-out freezer offers three storage levels. The full-width FreshChill pantry has temperature control. |
What sets the KRFC302ESS apart
The KRFC302ESS stands 72 inches tall and holds 21.9 cubic feet, with a pull-out freezer offering three storage levels. Its interior water dispenser draws from the supply line, a removable metal rack keeps wine bottles upright, and a full-width FreshChill pantry adds temperature control on the fresh-food side. The water supply needs 35 to 120 psi and a 115 V circuit.
Service notes for the KRFC302ESS
A pull-out freezer with three levels can jam if a basket is loaded beyond its limit, so an owner should check the drawer rails and the basket position. Filtered water dispensing that stops usually points to the filter or the supply, and the owner can check that the filter is in place. Freezer frost on a cabinet this tall is often tied to the door seal or a blocked air path. Compressor noise that runs nonstop points to a condenser issue for the technician. Ice maker or dispenser faults can sit with the water line. Keep the label digits and any code handy when booking.
Common issues for this model
- Freezer frosting up or not holding temperature
- Ice maker or dispenser not working
- Compressor or fan running loud or nonstop
- Water leaking inside or under the unit
Related error codes
KitchenAid Undercounter Codes E1 and E2: Power Cycle Only
KitchenAid undercounter units can show E1 or E2; its help gives a power cycle and does not name a cause.
KitchenAid Refrigerator PO Error Code Explained
PO is KitchenAid's outage indicator for refrigerators. Freezer temperature reached 18F (-8C) or higher; MEASURED FILL under Confirm acknowledges it.
KitchenAid Refrigerator Flashing F Code: What It Means
The flashing F on KitchenAid refrigerators is a general fault flag. Power-cycle the unit, verify cooling is on, and arrange service if the F persists.
KitchenAid Refrigerator / Beverage Center Code CL / LO: Temperature Too Low
A KitchenAid beverage center showing CL (or LO) reports that its internal temperature is too low.
Recommended repair service
Refrigerator Repair
Losing cooling, building frost, or pooling water? We diagnose KitchenAid refrigerator faults and restore reliable, efficient cooling.
Troubleshooting resources
Note how long the temperature has been off and whether the freezer side is affected too.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Frequently asked questions
Check the rating label on a side wall or the ceiling inside the fresh-food section, or behind the base grille. Use the full number, including any letters at the end.
Yes. We book in-home visits for this model in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Add the model number and the symptom to the booking form.
Note how long the temperature has been off and whether the freezer side is affected too.
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.